In the average home, the bathroom represents the majority of domestic water consumption. Average bathroom, most of the used water falls into the toilet. Standard toilets use three to five gallons of water to wash, while older models consume up to eight gallons. In addition to using a general-purpose toilet, the toilet is sometimes used to collect garbage and can pass hundreds of gallons through a leak. All this also increases the amount of water consumed in this source, as well as the cost of water in residential premises. Water saving can be done in a few minutes and with the use of economical tools.

The displacement bag

The toilet bowl is an offset bag that fills with water and fits into the toilet. It passes between the inlet valve and the tank wall. On the outside of the bag there is a handle that allows you to hang it on the side wall of the toilet bowl. This tool reduces the amount of water used during each wash using 0.8 gallons.

Tiny toilet water saver

The side discharge cycle is connected to the supply hose to reduce the amount of toilet water used during each discharge. To install, first pull the hose out of the overflow pipe. Remember to remove the clip if it is. Then enter the deviation of the filling cycle at the end of the hose. Finally, the deflector must be attached to the overflow pipe. The toilet cycle switch lever must be inside the overflow pipe and the other must be outside.

You have several options

A double convector for washing is a slightly more complicated water-saving toilet system that can save even more water, thousands of gallons a year. This device has two different rinsing options: liquid and full, or half full. Depending on the setting used, the transmitter knows how much water is needed to clean the tank with each color.

The installation of a double transducer is based on the type and type of toilet in which it is installed. Do not worry, all manufacturers provide detailed instructions for installing transducers and estimate that their assembly takes less than half an hour.

Even leakage can be annoying.

Periodic testing and repair of toilet leaks not only helps to prevent water loss, but also prevents loss of money. Leaking water is a water leak, but it is never used. Toilet waste is often quiet, making it difficult to detect.

The most common way to check for leaks is to use a coloring toilet mechanism pill that you can buy for a penny. Take the tablet and put it in the toilet. After about 15-20 minutes, if there is a drain, the water will change color. Another way to check if you have drainage in your hand is to install a leak detection device. Use a vibration signature from the filling valve to determine if a normal washing cycle will occur or if a re-supply reaction occurs in response to a valve leak.

Installing a water-saving device in the toilet is a simple way to make sure that your home has little water loss or water loss. The protection of toilet water also helps reduce the impact of our apartments on local water resources as well as our monthly budget.

Leave a Reply

Your email address will not be published. Required fields are marked *